menu Home Electric Cyclery Store Bionx conversion kits Schwinn electric bike Optibike electric bike Jackal electric bike Go-Ped ESR750 E-Glide electric skateboard eGO electric cycle Oxygen Lepton scooter ElecTrec bikes Folding bicycles Accessories and parts Vehicle carrier rack Reduce your impact Clean air legislation Why go electric? Related websites Site map Contact Electric Cyclery

E-Tek electric motor from Briggs and Stratton

The Jackal electric bike

Key Benefits
Programmable interface
Fault tolerant control inputs
Epoxy potted/Waterproof
Calibration software included with purchase.

The "AXE" by Alltrax.

24 to 48 volt input, 300 amp, fully programmable controller, plug in your computer with standard serial cable and load provided CD-ROM. Plug and play programming makes this controller an excellent choice for a wide variety of applications.

• Throttle ramp programming

• Throttle response rate

• Plug brake on/off, plug brake current

• High pedal disable on/off

• Battery over/under voltage cutback

• Maximum output current

Specifications:

• Operating Frequency: 18Khz
• Throttle Input: 0-5K ohms, 5-0K ohms, 0-5 volts, and ITS (inductive throttle sensor)
• Key Input Voltage: 8 volts to 1.5 times max battery volts
• Quiescent Voltage: less than 75mA
• Thermal Cutback: begins at 75C, 95C shutdown
• Programming Interface: RS232 serial to host PC running freeware Windows interface

  Current Limit: 300 amps
  30 second rating: 300 amps
  2 minute rating: 300 amps
  5 minute rating: 200 amps
  1 hour rating: 125 amps

• Voltage drop @ 100 amps = <.30 volts

© 2005 Electric Cyclery - All rights reserved.